Have you ever wondered what is inside your washing machine that cleans your clothes? Your washing machine has probably cleaned your clothes hundreds of times and you didn't even know how to do it. Just put the fabric in the softener and detergent, turn it on, and walk away to wait for it to finish.

To start

Before you attempt to wash your clothes, you have a few decisions to make. There are several settings you can choose from to ensure your clothes get washed properly without any disasters, such as not changing shape or size and dyes that work during pregnancy. Modern washing machines are easier to operate than the old ones. You need to choose the right temperature to wash your clothes as well as the right wash cycle. For example, if you are washing woolen clothing, the temperature to follow and the appropriate wool wash cycle are usually indicated on the clothing label. An appropriate detergent and/or softener should be added to the laundry tank. Now that you've mastered the basics, you can start washing. What's wrong with the machine and you might want to consider calling a Washing Machine Repair Dubai service.

the first step

The door will automatically lock and not open until the wash cycle is complete or you press the stop button. Here, the water that will flow into the washer usually comes from a hose that also goes to the cold faucet at your sink. It enters through a solenoid valve at the rear of the machine behind the panels. Most modern washers only have one solenoid for the cold water inlet, while many older washers may be connected to both hot and cold water. The water passes through the soap dish where it collects the detergent before moving to the drum. There is also a level switch that deactivates the water inlet solenoid when the desired level is reached.

the second step

The water is then heated. Inside the washing machine drum is a heating element that is used to heat the water. The element will continue to heat the water until the temperature reaches the setting you set before the cycle started. This temperature is controlled by a thermostat that turns the element on and off as needed.

the third step

When the correct temperature is reached, the cylinder will start to rotate in one direction. If you watch while the washing machine is in the wash cycle, you will notice that the drum will sometimes stop and then start spinning in the opposite direction. Spin speed and duration can also vary. Drum rotation is achieved using a drive motor and belt system. This is again controlled by the previously selected course.

the fourth step

At this point in the cycle, the clothes should be washed properly. The water should now drain from the jar. A small suction pump placed at the bottom of the cylinder is used for this purpose. This will pump the water into a pipe that leads to the water drain at the back of the washer.

the fifth step

Now most of the water has been removed from the drum, but our clothes will still be very wet. The washer will now begin a spin cycle that will very quickly spin the cylinder and expel most of the remaining water. Again, the pump will remove the excess water.

last step

At this point, the washer will be confident that the specified cycle has completed and will now allow you to open the door. Your clothes should be washed the way you want them to be. If you have a problem with your washing machine, you will need to contact Washing Machine Repair Abu Dhabi professionals for help.